Features

RF Control remotely controls Sennheiser EM6000, EM3732, EM2000 series and evolution G3 / G4 wireless receivers as well as Shure Axient, ULX-D and QLX-D receivers. It supports monitoring of all parameters provided by the Sennheiser remote control protocols and the Shure AMX/Creston protocols including:

RF level bargraph
AF level bargraph
Link Quality
Battery status information and run time
Device name
EQ type
COM settings (EM3732COM)
AF Out level
Squelch level
Mic / Gain offset
Lock status
Warning indicators (Low Bat, RX Mute, TX Mute, RF Mute, AF Peak, Encryption Mismatch, Interference)

All relevant parameters can be remotely controlled:

Frequency, bank, channel
Device name
EQ type
COM type
AF Out level
Squelch level
Receiver Mute

Also RF Control displays the RF and AF level over time in the plot window, making it the perfect companion for walk tests and spotting dropout in your audio.

The iPad version features a fullsize plot window for RF and AF levels. The levels are recorded and can be scrolled through to identify weak levels during the walk test.

The scan window provides an excellent overview of the RF environment. Optional packages will provide tools for further analysis of the scan data including:

Scan with any attached receiver
Single shot scan or cycle scan
Export to Dropbox or email account

Supported devices

RF Control currently supports following Sennheiser product lines:

ew G3 300 (EM 300)
ew G3 500 (EM 500)
ew G4 (EM 300-500)
2000 series (EM 2000, EM 2050)
EM3731, EM3732, EM3732COM
EM6000, EM6000Dante

RF Control currently supports following Shure product lines:

Axient (AXT 400)
ULX-D (ULXD4, ULXD4D, ULXD4Q)
QLX-D (QLXD4)

(Please note: Sennheiser IEM transmitter are currently not supported)

Requirements

RF Control requires firmware version 1.7.0 or higher to be present on Sennheiser 2000 series and ewG3 receivers. If your firmware version is lower the devices will still be found but will not respond to the control interface. The latest version can be found here.